Location:HOME > NEWS > The introduction of flange & bend

The introduction of flange & bend

2015-04-28 14:56:31   COMMENT:0 HITS:

  We(hebei Shengtian) would like to introduce ourselves as Manufacturers and Exporters of Pipe Fittings such as 45o, 90o and 180o Elbows, Bends, Equal & Unequal Tees, Stubends, Eccentric & Concentric Reducers, Caps etc. in Seamless and Welded quality in Stainless Steel, NACE, Alloy Steel, Carbon Steel, Duplex, Coupro Nickel, Monel, Copper, Titanium, Aluminium And Non ferrous materials. Fittings are manufactured as per National and International Codes and Standards. We also manufacture special type Bends with PE Coating and fittings as per customer specification and drawings.

  Flanged connections are in installations and constructions such as pipelines and oil platforms or cranes to wind turbines. To fit flange joints in a proper way a lot of knowledge and expertise is needed. From the design table to control flange connections, special procedures are required to maintain a certain quality. Flange Management has the knowledge to support this

previous_pageWhy fittings abroad is growing so fast
next_pageHow to install the flange

<ALL>